Auto Parts - Car and Truck Accessories
Jeep Exterior Accessories
Air Scoop ChromeHere is the Air Scoop Chrome, auto parts car truck accessories that you were searching for and sound systems, body kits, performance parts, starters, radiators, bumpers, consoles and Euro style parts, here is the right place for on-line shopping.Air Scoop Chrome
Increase the efficiency of your heater and air conditioner and improve airflow through your vents. Available in chrome plastic Easy Installation - No Drilling
 Progressive Rate Helper Springs
PROGRESSIVE RATE HELPER SPRINGS Bolt easily on leaf springs — no welding or drilling Ensure a factory-smooth ride when vehicle is unloaded, yet support up to 1,500 lbs. loads Includes two 2-1/2"W springs, all brackets and hardware, instructions. Some limited clearance vehicles use special design 2 spring kit. Note: Springs are designed to increase level-load carrying capacity. Never load vehicle beyond manufacturer's maximum GVW rating.
 1992-1993 Buick Riviera Front HPS Hawk Brake Pads
HPS - High Performance Street Superior Stopping Power HPS - High Performance Street disc brake pads are world renowned for increasing stopping power on your street legal vehicle. Increasing the performance of your vehicles braking system is easy when you choose Hawk Performance?s HPS braking compound. This unique Ferro-Carbon formula was developed for street performance using the safety and quality of Aerospace and Motorsports severe-duty friction technology. The High Performance Street compound offers a higher coefficient of friction over stock brake pads and can provide you 20-40% more stopping power and higher resistance to brake fade than most standard replacement pads. Less fade means you?ll have a highly durable brake pad with less brake dust.. HPS Ferro-Compound Features: ? Increased stopping power ? High friction/torque hot or cold ? Gentle on rotors ? Extended pad life ? Low dust ? Virtually noise-free All Hawk Performance High Performance Street brake pads provide a limited lifetime warranty, ensuring products to be free of defects from manufacturer?s workmanship and materials. Note: Hawk Performance burnishes its High Performance Street brake pads as a final step in the factory, but all brake pads have to be bedded-in with the rotors (new or used) that they will be used against. Properly bedding-in new brake pads results in a transfer film being generated at the pad and rotor interface to maximize brake performance. Brake Pad Installation Procedure 1. Install brake pads properly. Be sure pads are securely positioned in the caliper. 2. Flush system with fresh brake fluid. 3. Check all hydraulic parts for excess wear and tear. 4. Check disc for proper thickness, parallelism, and lateral runout. 5. Check disc for scoring or grooves over .012?depth. If either applies, resurfacing is required. 6. If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130 grit sandpaper using moderate pressure. Use soap and water to clean discs? surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid. 7. Inspect calipers for freedom of movement. Lubricate where necessary. Burnishing Instructions 1. After installing new brake pads, make 6 to 10 stops from approximately 30-35 mph applying moderate pressure. 2. Make an additional 2 to 3 hard stops from approximately 40 to 45 mph. 3. DO NOT DRAG BRAKES! 4. Allow 15 minutes for brake system to cool down. 5. After step 4 your new pads are ready for use.
Copyright 2004 - 2007 |